Rodinal stand development at 13 degrees celsius

rodinal; stand development; peterkinchington. I recently read that at low temperatures their is less grain/clumping when using rodinal. I found this to be true for Fomapan 100 sheet film when stand developed in 1:100 rodinal at 13 degrees for 2 hours. The following images were developed using this technique.

Rodinal - Pictorial Planet

For Stand Development dilute 1:100, develop for 1 hour or 1:200 and develop for 2 hours (for higher compensation). Agitate for the first minute and leave to stand for the remainder of the time. Maintain 18-20C in a water bath. Do not move the tank or film during this time. Any film or film speed will do but try it on something unimportant first!

Rodinal developer -

Appreciating Rodinal : The oldest commercial developer Gundlach Korona 5x7 with 4x5 back, Graphex Optar 135mm/4 I will modify the semi-stand development to using Rodinal 1:100, 30 seconds initial agitation followed by two inversion every ten minutes for twenty minutes Rodinal Developer uk, IG tedsmith_photography, FB tedsmithphotography) as our


3. Consider natural or man-made hazards which may impose limitations on development; 4. Conserve the City's natural beauty and visual character and minimize adverse impacts of development on the natural environment as much as is reasonably practicable; 5. Assure that development is supported with necessary public facilities and services; 6.

FilmDev | Recipes & dev times using Film Foma Fomapan 400

20 minutes at 20°C/68.0°F Rodinal 1+25 - 20 min @ 20C Ilfostop Stop Bath - 1 min@ 20C (reuse) Kodafix By Ok* on 04 April 2022 Foma Fomapan 400 in Agfa Rodinal 1:100 1 hour, 30 minutes (Stand developed) at 20°C/68.0°F Presoak for a few minutes. Agitate for one Minute. After that one inversion By Kamerakata on 28 March 44 recipes in total

Film developing with Rodinal - developing times, dilution, pull & push

Rodinal is a film developer, the recipe of which was introduced by Agfa in 1892 and which has been actively used since then despite the fact that photographic emulsions have undergone changes during this time. It is also worth noting that the formula of Rodinal also underwent some changes, mainly aimed at improving its shelf life.

Monochrome Madness: Rodinal Stand Developing

May 22,  · Rodinal is my favourite and only developer due to the fact it is so flexible. Plus, using such small amounts means it lasts for ages. My 125ml bottle will be good for 65 35mm

Stand development - Wikipedia

Stand development is a photographic development process where film is left in a very dilute developing solution for an extended period of time, 

Stand Development an Introdcuction - Daniel Hewes Photography

Jan 28,  · Stand Developed in Rodinal 1+100 for 50 minutes. Olympus OM-1, Fuji Acros 100, rated at 80. Stand Developed in Rodinal 1+100 for 50 minutes. Vivitar Ultra Wide & Slim, Kodak Tri-X 400. Stand Developed in Rodinal 1+100 for 1 hour. Olympus OM-1, Fuji Acros 100, rated at 80. Stand Developed in Rodinal 1+100 for 1 hour.

Question(s) about stand development - Film Forum

Hi all, I am thinking about stand development for 1 hour with Rodinal (1+100). I am guessing this is the most common and used developer and 

Stand Development - D76 Rodinal Sheet Film comparison

I used what I feel is a semi-stand development, or very low agitation technique. First was water pre-wash, for about 3-5 minutes, then pour off. Then 8 sheets developed in D-76 1+3 dilution, and 8 sheets developed in Rodinal 1+50 dilution. I adusted the times for temperature using the rule subtract 2% per 2 deg F over 68 deg F.

Help! Rodinal stand development problem

Rodinal stand development problem. May 16, 2021. FIlm: HP5+. ISO: 1600. Developer : Rodinal 1+100. Time: 120 minutes. Agitation:Only first minute.

Stand Developing HP5+ @ 1600 in rodinal : AnalogCommunity

Also, if you develop anything in Rodinal, even at 1+100, for two hours with standard agitations, everything will almost certainly be massively overdeveloped. It's called "stand development" because you just let it stand there without agitating.

Stand development - is it worth it? : r/AnalogCommunity - Reddit

I've just bought some rodinal after getting through most of my Ilfotec HC and I've been reading up on stand/semi-stand development and have 

Ilford XP2 Stand Developed in Rodinal -

Rodinal is an amazing developer. As Don Cardwell so tellingly puts it, rodinal and this method give both hard and soft tones at the same time! I'm thus going to develop my rolls of XP2 in rodinal using this semi-stand or minimal agitation technique. I hope it will complement your full-stand method, and I'll let you know the results.

My approach to Rodinal semi-stand film development

Feb 12,  · My approach is pretty simple: rodinal based chemistry, and slight agitation at certain points throughout the timeline, which makes it a semi-stand rather than a full stand.

Stand develop your film with Rodinal, Kodak or Ilford developer

Stand development is an old black and white film development method. Let's see how to do it with Rodinal, Ilford LC29 or Kodak HC110 !

Tutorial: Rodinal Stand Development - Andrew Kaiser

Dec 13,  · Relating that to film, during stand development the Rodinal will exhausts itself in areas which require greater development whilst remaining active in less-exposed areas, which

Comparing 4 B&W Film Development Techniques

4- Rodinal R09 – Dilution 1+100 – Developing time : 45 min (Stand development) Stand development : 1 minute agitation, then then sit.

Recipes for Rodinal Stand Development – wpwentzell | photo

Feb 23,  · This development sheet was developed for use with Tri-X film, but should prove effective for most films. One roll 35mm film (two reels in tank): 5ml per 500ml Rodinal to distilled water – Rodinal 1+100. One roll 120 film (one reel in tank): 6ml per 600ml Rodinal to distilled water – Rodinal 1+100. @ASA 400 • 5 minute water pre-soak.

Stand and semi-stand development of film

Dec 09,  · Of course, HC110 or D76 or Rodinal are about half the cost and provides beyond acceptable results. So, the above described process is simply known as ‘Development’ or developing your film. In Stand Development (SD), a much smaller amount of developer is used but, the time to develop it is extended significantly.